| Question by: |
Danny Davis KyoshoTomahawk-SRB-Dan 16/10/2011 14:39:07 |
| Question: |
Hey there Prof! what you think of my Decal tip which I always use to make it soo eeessseeey to apply new decals to my RC's -- So all you have to do is get a small bowl of warm water with a few small drops of blue or green washing up liquid in it ,, then when you are ready, just coat the area on your model and the Sticky back of the Decal with the water,, this means that you can carefully slide and readjust the decal position until you are happy,, then just carefull rub it over to squeeze out excess liquid... leave it to dry and squueeze out any air bubs,, then you should be All Good and a lovely Straight Sticker job... all you have to do is be careful not to use too much washing up.. No Probs. |
|
